/ How to make daytime running fire with your own hands?

How to make daytime running fire with your own hands?

Daytime running lights with your own hands
Currently, every car owner seeksmake your "iron horse" as comfortable as possible. However, at the same time, do not forget about security. Daytime running lights (DRL) will help to make your car more noticeable on the roadway, which, in turn, contributes to a significant reduction in the likelihood of emergencies. Therefore, the installation of such equipment becomes not only a pleasant, but also a necessary addition to the appearance of your vehicle.

What is required?

LED running lights with their own hands
If you firmly decided that the installation of runninglights with their own hands - the only way out for your car, you should immediately take care of the availability of all the required parts and tools. So, regardless of the model of your machine and the scope of work, you may need: a set of tools (keys, screwdrivers, pliers, etc.), electrical tape, adhesive composition (you can take both conventional superglue and bottled compounds with hermetic properties), soldering iron, a bundle of wires, lamps and a control device. Currently, LEDs are widely distributed. You can buy them at any auto parts store. In addition, LED navigation lights, installed by their own hands, look quite impressive, and costs require minimal. In addition, they have high technical characteristics, which allows them to find wide application.
Installation of navigation lights with your own hands

Theoretical information

To begin with, it is necessary to determine the place wherean DRL system will be installed. It should be remembered that it's easy enough to make daytime running fire with your own hands, it's important to only consider several rules and requirements. For example, the height restrictions (at least 250 mm from the ground surface) and width (no more than 400 mm from the side edge of the car) must be observed.

Mounting procedure

Once the exact location of the installation is selected, you canproceed to the practical part. First of all, all the details involved in the process will be required. This event directly depends on what and how it is arranged under the hood of your car. Therefore, daytime running lights can only be installed with your own hands if you know enough about your car. After that, all necessary measurements are made, on the basis of which the marking of the DRL location will be carried out in the future. At this stage it is very important to keep the symmetry of the structure. After similar preparations it is possible to mount daytime running fire with your own hands. A set of LEDs is attached to the selected points, then all necessary wires are attached. Traditionally, such a system is attached to the ignition key, so that DRL started to work when the engine starts, and turned off when the headlights are switched on. Thus, the daytime running light (with your own hands, for example, installed) is responsible for your safety even when you do not know about it.

comments